Menu

WFC News

Posted: Apr 1, 2018

Technology Continues to Enhance Aerial Fire Apparatus Operation

Technology, specifically electronics technology, has made deep inroads in positively affecting the performance and utility of aerial apparatus, whether platforms or straight sticks.

And with the increased use of technology on aerials, its deployment shows many benefits for firefighters operating and using the apparatus from safety perspectives to ease of use and ease of placement of the rigs.

Aerial Ladder Movements

Dave Reichman, national sales manager for Rosenbauer, says that at Rosenbauer, “Technology is the opportunity to keep everyone safer, and a byproduct of that technology is that we can make the operation of the aerial smoother for the operator.” Reichman notes that Rosenbauer’s Smart Aerial technology is standard on all its aerials, whether platforms, straight ladders, or tractor drawn aerials (TDAs).

“Smart Aerial is a tried-and-true system that, along with our programming—especially our soft touch controls—allows us to ramp down aerial movements so there is no jerking of the aerial,” Reichman says. “Soft touch controls buffer the movements so the aerial comes to a smooth stop and won’t allow any lateral whip.” Smart Aerial control screens are located at the turntable, the outrigger control station at the rear of the truck, and in the basket if an aerial platform.

1 Rosenbauer offers either an Aerial Command Seat (shown) or an Aerial Command Pedestal where an operator can use a joystick to operate the Smart Aerial system that controls the aerial device. (Photos 1 and 2 courtesy of Rosenbauer.)

1 Rosenbauer offers either an Aerial Command Seat (shown) or an Aerial Command Pedestal where an operator can use a joystick to operate the Smart Aerial system that controls the aerial device. (Photos 1 and 2 courtesy of Rosenbauer.)

Tim Smits, senior sales manager of aerial products for Pierce Manufacturing Inc., says that technology has affected Pierce’s line of aerial products, especially its Command Zone technology that programs many operational and safety features into the system. “Any standard multiplexed vehicle that Pierce builds has an Aerial Information Center as standard,” Smits points out. “The control screen is built into the turntable, and if we’re dealing with a platform, in the basket too.”

Smits notes that as the aerial moves, the control screen’s active load chart changes to determine the various loads that can be had for various aerial angles and height, as well as for reach and water flow. “The Aerial Information Center also shows data about tip control and the aerial tip temperature, something that’s important because if there is too much heat at the tip, the operator might have to move farther away.”

Paul Christiansen, aerial sales manager for Ferrara Fire Apparatus, says Ferrara recently rolled out a new line of aerial apparatus that use a motion control electrical system to control the ladder. “It allows for better control as far as extension and elevation,” Christiansen says, “and automatically feath

Read more
Posted: Apr 1, 2018

A Cold-Weather Fire Apparatus Close Call

Chris Mc Loone

It’s April, so what I should be writing about is something related to FDIC International 2018—maybe about the more than 700 exhibitors, or the more than 33,000 expected to attend, or how there isn’t a bigger conference and exhibition for the fire service in North America. But, as it often happens in life, events occur that change your plans.

Back in February, the Mid Atlantic region of the country had two Nor’easters occur within days of each other. The first tricked many meteorologists—although at this stage of the game my preferred way of weather prediction involves looking out a window—and what was supposed to be a rain and wind event became a wet snow and wind event. The nature of the storm took many by surprise, and it was not long before the whole area became gridlocked.

We got through most of the day without any calls, but the way it usually goes during weather events like this is that once the calls start, they don’t stop. Most of the calls involved trees into houses, wires down and arcing, and “trees and wires.” Every so often a noncommercial or commercial building fire dispatch would be thrown into the mix, and it was for a noncommercial building fire that I found myself behind the wheel of our first-out pumper.

It was slow going, and as soon as we left the ramp of the firehouse I turned to our captain and told him I was going to take my time as much as was feasible. Driving conditions were not good at this point, and there was no reason to make matters worse by driving like a madman.

We weren’t far from the address of the fire when we were recalled. I checked quickly with the captain to see what way he wanted to head back. We had a very curvy hill coming up, and if he wanted to try turning around, I was open to it. We decided to proceed down the hill. As I approached the hill, I noticed a few twigs falling from one of the trees to my left, which drew my attention to a line of trees. As I looked to see which tree was dropping branches, a large tree fell right in front of me within 10 feet. It was kind of slow motion watching it fall, and there was enough time for me to stop, thankfully.

As it came down, several things went through my mind in rapid succession. First, it became obvious that the timing was right, and I was not going fast enough for it to hit the truck, but if it did it would probably clip the front bumper. Once that computation went through, and concurrent with trying to stop, I thought, “If I slide, I’m going to hit this tree.” As luck would have it, I did not slide and came to a stop. Before I could even breathe a sigh of relief, a light show started to my right as the wires the tree briefly rested on snapped. Quickly, I started to back up, but there were vehicles behind me we had to contend with before I could really get far enough away. Eventually, we did end up turning around to start the 10-minute journey home that took us 25 to 30 minutes because of traffic conditions.

I’m not bringing all this up to tout my driving techniques. I’ve had some time to think about it and my actions, and I have to think I probably would have been going a little faster if it was raining—not much, but potentially fast enough that the tree could have hit part of the truck. It was very unnerving even backing up because there was a whole line of these trees, and the wind and wet snow were not letting up.

Read more
Posted: Apr 1, 2018

A Cold-Weather Fire Apparatus Close Call

Chris Mc Loone

It’s April, so what I should be writing about is something related to FDIC International 2018—maybe about the more than 700 exhibitors, or the more than 33,000 expected to attend, or how there isn’t a bigger conference and exhibition for the fire service in North America. But, as it often happens in life, events occur that change your plans.

Back in February, the Mid Atlantic region of the country had two Nor’easters occur within days of each other. The first tricked many meteorologists—although at this stage of the game my preferred way of weather prediction involves looking out a window—and what was supposed to be a rain and wind event became a wet snow and wind event. The nature of the storm took many by surprise, and it was not long before the whole area became gridlocked.

We got through most of the day without any calls, but the way it usually goes during weather events like this is that once the calls start, they don’t stop. Most of the calls involved trees into houses, wires down and arcing, and “trees and wires.” Every so often a noncommercial or commercial building fire dispatch would be thrown into the mix, and it was for a noncommercial building fire that I found myself behind the wheel of our first-out pumper.

It was slow going, and as soon as we left the ramp of the firehouse I turned to our captain and told him I was going to take my time as much as was feasible. Driving conditions were not good at this point, and there was no reason to make matters worse by driving like a madman.

We weren’t far from the address of the fire when we were recalled. I checked quickly with the captain to see what way he wanted to head back. We had a very curvy hill coming up, and if he wanted to try turning around, I was open to it. We decided to proceed down the hill. As I approached the hill, I noticed a few twigs falling from one of the trees to my left, which drew my attention to a line of trees. As I looked to see which tree was dropping branches, a large tree fell right in front of me within 10 feet. It was kind of slow motion watching it fall, and there was enough time for me to stop, thankfully.

As it came down, several things went through my mind in rapid succession. First, it became obvious that the timing was right, and I was not going fast enough for it to hit the truck, but if it did it would probably clip the front bumper. Once that computation went through, and concurrent with trying to stop, I thought, “If I slide, I’m going to hit this tree.” As luck would have it, I did not slide and came to a stop. Before I could even breathe a sigh of relief, a light show started to my right as the wires the tree briefly rested on snapped. Quickly, I started to back up, but there were vehicles behind me we had to contend with before I could really get far enough away. Eventually, we did end up turning around to start the 10-minute journey home that took us 25 to 30 minutes because of traffic conditions.

I’m not bringing all this up to tout my driving techniques. I’ve had some time to think about it and my actions, and I have to think I probably would have been going a little faster if it was raining—not much, but potentially fast enough that the tree could have hit part of the truck. It was very unnerving even backing up because there was a whole line of these trees, and the wind and wet snow were not letting up.

Read more
Posted: Apr 1, 2018

Pierce Prince Georges County (MD) Ladder Truck

Ladder trucks come in various sizes and lengths depending on the manufacturer. They also have a tendency to grow in size after a committee works to squeeze in as many tools and equipment as possible. Then it tries to add as many functions as possible to enhance its all-hazard status out on the street.

Some ladder trucks can become monsters and can certainly break the bank. So, the build of a simple, small, compact truck designed to do “truck work” was a privilege to see.

Approval to Build

In 2016, the Prince George’s County (MD) Fire/EMS Department was approved by the county government for a ladder truck replacement at its Oxon Hill fire station. Prince George’s County is located right outside of Washington, D.C., and is one of the nation’s largest combination departments. Chief Benjamin Barksdale leads more than 850 career firefighters and paramedics and 1,500 volunteer firefighters who operate out of 45 stations. The county protection district covers more than 500 square miles, and the department responds to more than 150,000 calls for service each year. The volume of responses is anticipated to grow because of the rapid pace at which the county is growing in industry and housing over the next couple of years. This particular station has a very diverse building stock in its first due. These structures include many single-family dwellings, large garden apartment projects, the National Harbor, and the MGM Grand Hotel & Casino on the banks of the Potomac River. Oxon Hill’s Truck 821 is one of the county’s busiest truck companies and was previously operating a 2005 Seagrave 100-foot rear-mount aerial.

The project to replace this rig took many people to ensure money was correctly allocated and the right apparatus was selected. So, putting together the right team to have the best end product was the direction from Barksdale and the deputy chief of support services, Joe Cardello. The department had used the Pierce Arrow and Velocity chassis for its latest order. During these delivery times, Pierce came out with the Enforcer chassis. The frame rails on this chassis are 10 inches high rather than the 13 inches that the department had previously used. There was a lot of discussion over this change within the department overall and the maintenance division. But in the end, the decision was made to go with the Enforcer cab. This frame height reduction also helped with a height issue at the Oxon Hill fire station. The department is pleased with the Enforcer cab and currently has six engines on order with the same cab as the truck and hopes to have them out in the field very soon.

PGFD Truck 821

• 39-foot 8-inch overall length

• 230.5-inch wheelbase

• 11-foot 8-inch overall height

• 147 inches of body past center axle

• 68,000-pound GVWR

• 20,000-pound front axle

• 48,000-pound rear axle

PGFD Truck 821

• Electronic stability control

• Detroit DD13 525-horsepower motor

• Allison transmission

Read more

Posted: Apr 1, 2018

Pierce Prince Georges County (MD) Ladder Truck

Ladder trucks come in various sizes and lengths depending on the manufacturer. They also have a tendency to grow in size after a committee works to squeeze in as many tools and equipment as possible. Then it tries to add as many functions as possible to enhance its all-hazard status out on the street.

Some ladder trucks can become monsters and can certainly break the bank. So, the build of a simple, small, compact truck designed to do “truck work” was a privilege to see.

Approval to Build

In 2016, the Prince George’s County (MD) Fire/EMS Department was approved by the county government for a ladder truck replacement at its Oxon Hill fire station. Prince George’s County is located right outside of Washington, D.C., and is one of the nation’s largest combination departments. Chief Benjamin Barksdale leads more than 850 career firefighters and paramedics and 1,500 volunteer firefighters who operate out of 45 stations. The county protection district covers more than 500 square miles, and the department responds to more than 150,000 calls for service each year. The volume of responses is anticipated to grow because of the rapid pace at which the county is growing in industry and housing over the next couple of years. This particular station has a very diverse building stock in its first due. These structures include many single-family dwellings, large garden apartment projects, the National Harbor, and the MGM Grand Hotel & Casino on the banks of the Potomac River. Oxon Hill’s Truck 821 is one of the county’s busiest truck companies and was previously operating a 2005 Seagrave 100-foot rear-mount aerial.

The project to replace this rig took many people to ensure money was correctly allocated and the right apparatus was selected. So, putting together the right team to have the best end product was the direction from Barksdale and the deputy chief of support services, Joe Cardello. The department had used the Pierce Arrow and Velocity chassis for its latest order. During these delivery times, Pierce came out with the Enforcer chassis. The frame rails on this chassis are 10 inches high rather than the 13 inches that the department had previously used. There was a lot of discussion over this change within the department overall and the maintenance division. But in the end, the decision was made to go with the Enforcer cab. This frame height reduction also helped with a height issue at the Oxon Hill fire station. The department is pleased with the Enforcer cab and currently has six engines on order with the same cab as the truck and hopes to have them out in the field very soon.

PGFD Truck 821

• 39-foot 8-inch overall length

• 230.5-inch wheelbase

• 11-foot 8-inch overall height

• 147 inches of body past center axle

• 68,000-pound GVWR

• 20,000-pound front axle

• 48,000-pound rear axle

PGFD Truck 821

• Electronic stability control

• Detroit DD13 525-horsepower motor

• Allison transmission

Read more

RSS
First48504851485248534855485748584859Last

Theme picker

Search News Articles